CFMCalc

Disclaimer

Last updated: 2026-11-17

Everything on CFMCalc is an estimate produced from the values you enter. It is offered in good faith, using published constants and standard formulas, and it is still only arithmetic.

Not professional advice

Consumption figures are published averages for typical tools, not measurements of your equipment. A calculation cannot see your site, your materials, your equipment or your circumstances. Where a decision carries a cost or a risk, take advice from someone qualified who can look at the actual situation.

Verify before you rely on it

  • Check the result against your own measurements.
  • Confirm anything regulated with the body that publishes the rule.
  • Read the coverage figure on your own product rather than assuming the conventional one.
  • Buy or commit in stages where a mistake would be expensive.

Data sources

Where this site publishes data rather than arithmetic, the source is named on the page that shows it. The main sources are:

  • Nailer manuals for air use per drive: DeWalt D51257, D51276, D51321 and D51823, and Ridgid R213BNA
  • Paslode F-350S published air consumption per shot at 90 and 120 PSI
  • Colorado State University Extension, sprinkler system blowout guidance
  • Hunter Industries, sprinkler blowout pressure guidance

Those sources carry their own accuracy limits, which are described on the methodology page. Where a figure depends on an assumption, the page that shows it says so.

No liability

See the terms of use. In short: we are not liable for losses arising from reliance on an estimate, and you should not rely on one where the consequence of being wrong is serious.